Mar-15 9:12:41 PM Z-Wave Warning Device Reset Locally Notification received for node 72 - NODE IS BEING REMOVED FROM THE SYSTEM. It takes a little work to get it back up and running again. Each time I try it gets stuck at a different location and hangs the z-wave interface (Smartstick). I haven't tried using the non-secure add yet, but here's the log info I get when trying to add (note oldest is at the bottom). Sometimes it even disappears or kills the complete HS3 application (happens two times when trying to synchronize association info). But I see no information in the Zwave tab of the Wallmote root device. The log gives no errors, it says there are nine associationgroups availbale. The z-wave tab of the root-device disappears when I try to retrieve. No luck for me with retrieving association info of the Wallmote. Note that mine has version 1.0 of the firmware, so it may not act the same. This will keep the device awake so the association is set. The trick is to press the button on the back a few times after you press the association button in HS. I associated group 2 with one other Z-Wave device and it controlled it ok. However, I did try the associations and I could set them. Do you want to associate the device directly with another device? That is the easiest and best way to set it up. Just have HS trigger on the scene that is pressed (button), then have HS issue a command to the device you want to control.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |